Here is a simple list of items and steps from the video below:

• 1.5 metres of 25 gauge magnet wire
• One AA battery
• Wrap the coil around the battery leaving about 4 centimeters of wire on each side
• Carefully slide the coil off of the battery
• Loop the ends of the coil around each side twice exactly opposite from each other.  This is important as the ends will act as a rotor
• If the wire is coated, remove a little bit of the coating on each end with and paper
• 2 thin pieces of bendable metal for brackets  and cut 5cm x 1cm pieces
• Fold them each in the center and make a small hole near the end of each metal bracket with a tack or small nail
• Get a small disc shaped magnet
• Center the magnet on a small piece of wood and place the brackets down on each side of the magnet with a little bit of space, using thumbtacks
• Secure pieces of wire to each bracket with metal touching metal
• Slide the coil into the brackets aligned straight and slide the magnet into place under the coil
• attach the wires from the brackets to the AA battery and watch it run!